Inetone: Raspberry PI5

Dies ist Version . Es handelt sich nicht um die aktuelle Version und kann folglich auch nicht geändert werden.

[Zurück zur aktuellen Version][Diese Version wiederherstellen]

24.03.2024

Inhaltsverzeichnis

Raspberry PI5 8GB
Case
OS
Samba
Temperature and Power
Logitech Squeezebox Radio
Install LMS (Logitech Media Server)
Custom URL

Raspberry PI5 8GB#

Getting Started

Case#

I used the case "Raspberry PI5 Case Acryl with FAN" from mindfactory. There seem to be many different "acryl cases" in the market, e.g. you cannot expect to get the same everywhere. My fan in this package had a two pin adapter only, which you can apply to the GPIO pins 4+5

but then the fans runs always, which is too loud. You should use the official 4 pin fan connector, e.g. buy a package with a proper fan! I guess with the 4 pins it is with PWM signal that allows the computer to change the speed of the fan.
Finally I disabled the fan as I have only max 60°C only (see temparature).

OS#

I installed Raspberry PI 5 / Raspberry PI OS 64bit on 128GB microSD via Imager Software
Note: Settings has three tabs !

name = raspberrypi5
Enable SSH !
Enable WLAN

Update:

sudo apt-get update
sudo apt-get upgrade
sudo reboot

The Squeezebox Radio needs an IP address (see below), so I activated in FritzBox to give the same IP always to "raspberrypi5".

Samba#

Add samba service to share with windows

>sudo apt-get install samba
# Samba user, same password:
> sudo smbpasswd -a <user>
> sudo mkdir /var/log/samba
}}
> sudo vi /etc/samba/smb.conf
add something like:
[global]
 workgroup = WORKGROUP
# MARKUS ADDED
 netbios name = LINUXSERVER
 lanman auth = no
 ntlm auth = yes
 client lanman auth = no
 wins support = yes
 local master = yes
 preferred master = yes

# MARKUS ADDED
[Musik]
 comment=Raspberry Pi Share
 path = /media
 browseable = yes
 writeable = yes
 read only = no
 only guest = no
 create mask = 0775
 directory mask = 0755
 public = no
 force user = markus

Write permissions on windows are shared on Linux level:

> sudo chmod a+rwx /media

Linux Commands
note: you see the shares used only if some user uses currently, otherwise check config

> sudo service smbd restart
> sudo smbcontrol all reload-config
> samba --version => Version 4.17.12-Debian
> systemctl status smbd
> sudo smbstatus
> sudo smbstatus --shares
> sudo pdbedit -L -v
> cat /var/log/samba/log.smbd

In Windows use
\\raspberrypi5\Musik => Anmelden

Temperature and Power#

Power
You cannot properly messure power consumption in PI, app "powertop" cannot be used due to missing batterie.

 > vcgencmd measure_volts => volt = 0,7200V

I used a smart power adapter from Gosund to check:

3,0 - 3,4W while idle/streaming
3,6 - 3,9W while copying files via Samba

Temperature
You can use Linux for checking that:

 > sudo cat /sys/class/thermal/thermal_zone0/temp

Some Linux background about temperatures:
see folder /sys/class/thermal/
=> zones, PI5 has one only = thermal_zone0
note: values like 60050 = 60,05°C

file	description	value
type	Type of the thermal zone	cpu-thermal
temp	Current temperature	56,0 - 60,5 °C without fan in arcyl case
mode	Working mode of the thermal zone	enabled
policy	Thermal governor used for this zone	step_wise
available_policies	Available thermal governors for this zone	step_wise
trip_points	temp=temperature/type=type/hyst=Hysteresis value for this trip point	0 critical / 110 °C / 0
		1 active / 50 °C / 5
		2 active / 60 °C / 5
		3 active / 67,5 / 5
		4 active / 75 °C / 5
slope	Slope constant applied as linear extrapolation	-550
sustainable_power	Sustainable dissipatable power	0
k_po	Proportional term during temperature overshoot	0
k_pu	Proportional term during temperature undershoot	0
k_i	PID's integral term in the power allocator gov	0
k_d	PID's derivative term in the power allocator	0
integral_cutoff	Offset above which errors are accumulated	0
offset	Offset constant applied as linear extrapolation	450000

Current CPU frequency

 > cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_cur_freq => 15000000
 > vcgencmd measure_clock arm => frequency(0)=1500004352

Logitech Squeezebox Radio#

See mysqueezebox

| forum1

| forum2

| LMS (Logitech Media Server) Downloads

| LMS Getting Started

I followed more or less StepByStep Instructions by Harald Kreuzer.

Disable swap file

sudo service dphys-swapfile stop
sudo systemctl disable dphys-swapfile
sudo apt-get purge dphys-swapfile
sudo apt autoremove

sudo vi /boot/firmware/cmdline.txt
ADD at the end of line >noswap<
console=[...] noswap

sudo vi /etc/fstab
ADD:
# Log to RAM
tmpfs   /tmp            tmpfs   defaults,noatime,nosuid,mode=1777,size=256m 0 0
tmpfs   /var/log        tmpfs   defaults,noatime,nosuid,mode=0755,size=128m 0 0
tmpfs   /var/tmp        tmpfs   defaults,noatime,nosuid,mode=0755,size=128m 0 0

Install LMS (Logitech Media Server)#

sudo apt-get install libsox-fmt-all libflac-dev libfaad2 
sudo apt-get install libio-socket-ssl-perl 
sudo apt-get install libcrypt-openssl-bignum-perl 
sudo apt-get install libcrypt-openssl-random-perl 
sudo apt-get install libcrypt-openssl-rsa-perl 
# download ARM version Debian !
wget https://downloads.slimdevices.com/LogitechMediaServer_v8.5.0/logitechmediaserver_8.5.0_arm.deb
(note: NOT the ARM tgz = .tar.gz => tar xvf *.tgz)
sudo dpkg -i logitechmediaserver_8.5.0_arm.deb
# to test at window you need lame too
sudo apt-get -y install lame

LMS Commands

sudo service logitechmediaserver start
sudo service logitechmediaserver stop
sudo service logitechmediaserver restart

WebGUI: http://raspberrypi5:9000/ You can listen to selected stream with http://raspberrypi5:9000/stream.mp3

Enable at radio
Settings in radio see https://lms-community.github.io/getting-started/migrate-from-uesr-de/

UPNP/DLNA => Settings > Plugins verwalten > enable "UPnP/DLNA Media Interface (v1.0)

Custom URL #

Note: WebGUI > Radio > URL laden - does not save the URL

Create m3u file like

format:

#EXTM3U  <= must be first line 
#EXTINF:<seconds>,<track title>

examples:

#EXTM3U
#EXTINF:295,Starlight Express - AC/DC
MyCDs\Starlight Express - Starlight Express, Bochum 1991\Starlight Express - 05 ACDC.mp3

#EXTM3U
#EXTINF:0,Radio BOB
http://streams.radiobob.de/bob-national/mp3-192/mediaplayer

2. copy in the folder which is configured in settings > Grundeinstellungen > Wiedergabenlisten-Ordner
3. After changes: Settings > "Durchsuchen starten" (auch für Wiedergabelisten)
4. At radio you can choose Eigene Musik > Wiedergabelisten; you can even save that as favorite